{"product_id":"bsi-141-foam-cure","title":"Bob Smith Industries Foam-Cure Foam Safe Glue (1oz)","description":"\u003cp\u003eFOAM-CURE is a silicone based adhesive that works very well on EPP and EPO foams. It is crystal clear and cures to a more flexible consistency than CA. It is, however, not instant bonding like CA and there is no accelerator to speed it's curing. To obtain a faster initial bond when bonding two pieces, FOAM-CURE can be applied to one piece and after the two are joined, they can then be pulled apart. After letting it air dry for about ten minutes, FOAM-CURE will act like a contact cement when the parts are rejoined, resulting in enough tack strength to allow the next steps of assembly. Full strength is reached in 10-12 hours.\u003c\/p\u003e\n\u003cp\u003eFOAM-CURE works with all foams, and will actually bond most other materials. It will bond wood and plastic to foam, and is a good canopy glue. FOAM-CURE does not, however, cure flexible enough to act as a hinge for aircraft control surfaces. Its limitations occur when bonding large areas of two non-porous materials. FOAM-CURE requires exposure to air for drying. If one tried to bond, for example, a half-dollar coin to glass, over 90% of the adhesive would never cure, since the solvent it contains would have no where to evaporate. A small amount of denatured alcohol can be mixed into the Foam-Cure to make it thinner.\u003c\/p\u003e\n\u003cp\u003e\u003cb\u003eWorks Best On:\u003c\/b\u003e\u003c\/p\u003e\n\u003cul\u003e\n\u003cli\u003eEPP Foam\u003c\/li\u003e\n\u003cli\u003eEOP Foam\u003c\/li\u003e\n\u003cli\u003eClear Canopy\u003c\/li\u003e\n\u003cli\u003ePaper and Crafts\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003cp\u003e\u003cb\u003eDirections:\u003c\/b\u003e\u003c\/p\u003e\n\u003cp\u003eCut off tip of nozzle. Apply to one part before joining. Use tape to hold parts in place during cure. For faster curing, pull the joint apart and let Foam-Cure air dry for 5-10 min before rejoining the parts. This results in enough tack strength to allow the next steps of assembly. Full cure takes 10-12 hours. Foam-Cure works on all foams, especially on EPP and EPO, and will bond a porous surface to non-porous materials. Foam-Cure is also an excellent glue for clear canopies, and will also bond paper. If needed, denatured alcohol can be used to thin or clean up uncured Foam-Cure. Replace cap after use.\u003c\/p\u003e","brand":"HPD","offers":[{"title":"Default Title","offer_id":22410111025212,"sku":"bsi141","price":5.99,"currency_code":"CAD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0018\/4644\/4092\/products\/bsi141.jpg?v=1588862990","url":"https:\/\/docs-hobby-shop.myshopify.com\/products\/bsi-141-foam-cure","provider":"Docs hobby shop","version":"1.0","type":"link"}